Training in practice
First session: procedure and exercises
Once your EMS system is set up, you can prepare your first session. Here you will learn how to set the intensity and combine the pulses with simple exercises. Clarify any health questions with a doctor beforehand.

Warm up before the session
Before EMS training, warm up gently for at least five minutes until your skin under the electrodes is slightly moist. The fine film of sweat improves skin contact so that the pulses are transmitted better.
Set and increase the intensity
The pulse intensity can be set from 0 to 100 for each muscle group. Start the first few minutes at a low intensity (e.g. level 3). If the pulses feel comfortable, you can gradually increase the strength, for example up to level 10. If you want a little more tension, work your way up in small steps, for example in the range of 10 to 20. Stay at the level that feels right for you.
Set each muscle group individually. A higher level may feel comfortable on the legs compared with the arms or upper body. The tension should remain noticeable and comfortable. If a pulse becomes unpleasant, turn down the muscle group concerned.
To start, plan one session a week of 12 to 15 minutes, then increase to around 20 minutes. Start each session at a low intensity again, even if you finished your last session at a higher level.
Which types of training can I combine with EMS?
Your wireless EMS suit can be built into different workouts. Here are some examples:
First learn the movements without pulses and get used to EMS gradually. Choose the programme and intensity so that you can perform your movements in a controlled way. For outdoor training: protect the suit and PowerBox from rain and moisture.
| Type of training | Examples |
|---|---|
| Strength training | Bodyweight exercises or exercises with dumbbells |
| Sling training | Pulling, pushing and plank exercises with the sling trainer |
| Yoga and calm movement | Controlled movement sequences and held positions |
| Endurance training | Nordic walking, jogging or training on an exercise bike |
Learn the movement first
Learn new exercises without pulses first. Use a stable, non-slip surface and enough space. Only choose variations you can perform in a controlled way.
Combine exercises with EMS
In the Fitness programme, pulse and pause alternate. Tense up or perform the movement during the pulse and relax during the pause. Choose the intensity and repetitions so that every movement stays clean, and only increase once it is secure.
If an exercise does not suit you
Stop if you feel pain, dizziness or discomfort. A simpler variation is often more sensible than a sloppy movement. If complaints persist, have the cause checked by a professional.
Squat
Place your feet about hip-width apart, push your glutes back and straighten up again in a controlled way.
Only go as low as you can while staying stable and pain-free. Your knees follow your toes.
Lunge
From standing, take a step forward, bend both knees and return.
If you have balance problems, hold on to a firm support.
Standing row
Lean your upper body slightly forward and draw your elbows back along your body in a controlled way.
Keep your back stable; without pulling resistance, this is a movement exercise.
Forearm plank
Rest on your forearms, keep your shoulders above your elbows and your trunk in a straight line.
If necessary, put your knees down. Keep breathing and do not let your back sag.
Glute bridge
Lying on your back with your feet on the floor, slowly lift your pelvis and lower it again.
Control the movement and do not overextend your lower back.